SAILTEC's Kobelt Hydraulische Steuerung Katalog - page 50

h y d r a u l i c s t e e r i n g a n d a c c e s s o r i e s
This unit is designed for many shipboard and industrial
applications where low pressure and a small source of hydraulic
pressure is required.
It is available with either a 12 or 24 volt DC motor and is intended
for intermittent use only. It lends itself extremely well to manual
steering systems where a source of pressure is required to
operate the steering cylinder in conjunction with an autopilot.
It could also be used in raising and lowering hatches, masts
and tables.
The maximum amperage that the motor can handle on an
intermittent basis is approximately 30 amps for a 12 volt motor and
15 amps for a 24 volt motor. We do, however, recommend that the
motor should not draw any more than 16 amps for the 12 volt motor
and 8 amps for the 24 volt motor. The table below indicates the
capabilities of the motor. Adjustable safety valves for both port and
starboard are provided and flow control screws provide adjustment
for the variable delivery from 40 to 250 cubic inches per minute.
The lock valve fitted on the pump is to prevent hydraulic feedback
from the steering system. Both pump and motor are equipped with
ball bearings. The pump is made of silicon bronze, stainless steel
hardware with hardened steel pistons and wear plate.
To order this unit with the reversing relays, the part number is:
7201-PR12 (12 volt) or
7201-PR24 (24 Volt)
Please specify 12 or 24 volt.
Please Note!
Pump, relay & auto pilot should be the same voltage.
15.0 lbs. (6.8 kg)
7 2 0 1 - P R
A u t o p i l o t P u m p R e l ay s
1...,40,41,42,43,44,45,46,47,48,49 51,52,53,54,55,56,57,58,59,60,...68
Powered by FlippingBook