SAILTEC's Cantalupi SEALED Katalog 2015 - page 23

23
The SEALED
®
MyA are designed to offer two
protection barriers against the external water
pressure. Each barrier is tested through dedicated
procedures in compliance with the naval
certiications:
1st Barrier: External flange – Tempered glass –
Counter flange screwed to the Cofferdam.
This is the irst and most important protection
against the water pressure. The External flange,
the Tempered glass and the Counter flange
hinged to the Cofferdam form a single body that
guarantees the perfect watertight protection. In the
lab a 320 kPa pressure is applied to this part to
pass the test.
2nd Barrier: Cofferdam.
The Joint flange and the rear hatch close the
Cofferdam making the case completely watertight.
This is the last and ultimate barrier against the
accidental water ingress. It grants the maximum
safety level to the SEALED
®
MyA. The Cable
gland located on the Cofferdam is watertight and
capable to resist to the highest pressures.
WATERTIGHT PROTECTION
1
st
Barrier
320 kPa
FIXTURE COMPOSITIONING
The materials used are of the best quality to
SEALED
®
MyA able to resist to the harshest
envirorments.The Light Body (ig.1) is assembled
and sealed in one piece fromt the factory.
It is composed by three elements:
External flange – Tempered glass – Lighting Core.
The Tempered glass is 15mm thick and highly
resistant to the impacts.
The aluminum relector, offers the widest beam
angle for the maximum light eficiency.
In the MyA model, through the innovative
Trim & Lock
®
system, the Light Body can be
angled within a range of 50° (+ /- 25°) to
compensate the most extreme angles of the hull
and offer an even illumination around the yacht.
This is the best and most innovative solution
present in the market.
The SEALED
®
MyA allows to keep costs down,
to maximize the power output of the LEDs and
improve the hydrodynamic eficiency. rotating the
the Light Body by 90° it is possible to angle the
light horizontally and give to the designers the
opportunity to create innovative and unique
scenarios. The Trim & Lock
®
system widens the
creativity offering alternative light effects in the
water like the fishbone or Diamond effect.
The half shelf Cofferdam facilitates the operation
for the removal of the Lighting Core.
figure 2 shows how easy is to remove the
Lighting Core from inside the hull without hauling
the yacht should servicing ever be required.
MYA
-
SERIES
Lighting Core
Fig.2
Fig.3
Lighting Core
External flange
Tempered glass
Fig.1
Trim & Lock
®
System
2
nd
Barrier
320 kPa
1...,13,14,15,16,17,18,19,20,21,22 24,25,26,27,28,29,30,31,32,33,...68
Powered by FlippingBook